Gal kas patarsit kas per gedimas. Kompas raso , kad vairo posukio kampo (G85) mechaninis gedimas, ne elektrines grandines, o butent mechaninis. Pagal isore jokiu gedimu mechaniniu nesimato. Automobilis Audi A3 2001m, bet cia tur but visu modeliu vienodai, pas kuriuos yra ESP.
Pasidomejau biski, tai gali but,kad tiesiog apdulkejo tas jutiklis, tai reiktu isardyt, atsargiai isvalyt nieko nesugadinant ir surinkus sukalibruot. Sukalibruot galima su VAG COM.
Jau buvau pilnai isardes, bet ten viskas svaru,del sukalibravimo tai nezinau kaip, dar tiek neismokau. Jeigu kas parasytumet proceduros eiliskuma buciau labai dekingas,bent jau kuriame kanale galima pamatyti pasukimo laipsnius.
This procedure details how to perform the zero position calibration for the Steering Angle Sensor (G85) in many VW/Audi vehicles equipped with ESP (Electronic Stability Program). This procedure should be performed when vehicle alignment is performed or if any of the following components have been removed or replaced:
*ABS/EDL/ASR/ESP control unit (J104)
* Steering Angle Sensor (G85)
* Steering Column
There are certain test conditions that must be met before doing this procedure:
*Start the vehicle.
* Turn the steering wheel one turn to the right and one turn to the left.
* Drive in a short distance straight line on a level surface at a speed not higher than 20 km/h.
*If the steering wheel is straight during the test drive then stop the vehicle with the wheels pointed straight
*Ensure that the steering wheel is not moved again.
* Keep the engine running and do not switch off the ignition.
Procedure for performing the zero position calibration for the Steering Angle Sensor (G85) on VW Golf, GTI, Jetta, and Audi TT:
[Select]
[03 - ABS Brakes]
[Login - 11]
Enter 40168
[Do It!]
[Basic Settings - 04]
Group 060
[Go!]
This will store the zero (centered) position of the steering wheel. There should be a displayed message that reads: "Steer. angle sender compens OK". If you get an error, it may mean the Login was not successfully performed.
Click the [Done, Go Back] button and you're all set.
Procedure for performing the zero position calibration for the Steering Angle Sensor (G85) on VW Passat and Audi A4/S4, A6/S6, and A8/S8:
[Select]
[03 - ABS Brakes]
[Login - 11]
Enter 40168
[Do It!]
[Basic Settings - 04]
Group 001
[Go!]
This will store the zero (centered) position of the steering wheel. There should be a displayed message that reads: "Steer. angle sender compens OK". If you get an error, it may mean the Login was not successfully performed.
Click the [Done, Go Back] button and you're all set.
Nu sutaupei kruvele pinigu Jei netingi padaryk lietuviska "pasidaryk pats" tema kaip sukalibruot Info is cia: http://www.ross-tech.com/vag-com/cars/steeringangle.html Jau kelinta kart sprendziant diagnostikos klausimus mane googlas cia atveda
Aukštyn
FACEBOOK
Atsijungęs
Jei netingi padaryk lietuviska "pasidaryk pats" tema kaip sukalibruot 
Šiandien gimtadienius švenčia:
Sveikiname!
